The China's Leading Heating Element Manufacturer

How to choose size

Home    更新    How to choose size

 

The mica band heaters inside diameter should be equal to the outside diameter of the plastic machine’s barrel. The diameter must be exact since a difference would be compounded by a factor of pi (3.1415926) on the circumference of the band. This would mean that a 1/4” (0.250”) error on the diameter results in a shortage or overage of approximately 3/4” (0.785”) on the circumference. In those rare cases when the barrel diameter cannot be measured with accuracy, it is advisable to specify an adjustable heater band with the approximate range. When all else fails, it is better to estimate heater diameter slightly smaller as opposed to too large. This would ensure adequate tightening of the heater, provided the difference is no greater than 1/4” on the diameter dimension. If a heater with too large a diameter is used, the ends will come together and prevent the heater from being drawn to the cylinder. However, the exact dimension is necessary for optimum heater performance.

 

Mica band heaters are designed for “contact” heating as opposed to radiant heating, and therefore must be secured against the barrel of the plastic molding machine. If the band heater is not tightly clamped against the barrel it is possible for the heater to expand away from the barrel. This would cause air gaps between the barrel and the band heater, resulting in poor heat transfer, shorter life, excessive heat loss, and wasted electrical energy. Operating sheath temperatures should not exceed 300°. (Note that this rating is for the heater’s sheath-not the process.)

 

A rough spot or foreign material on the barrel can greatly reduce the life of your band heater.  A small particle can leave an air gap on either side of itself which can cause a “hot spot.”  Air will not conduct the heat away from your heater as fast as the metal of the barrel.  This results in a spot on the heater where the temperature will be significantly hotter than the rest of the heater.

 

When you are ready to call LAIYUAN HEATER and speak to one of our sales engineers to order a heater, please specify the following information:

 

Quantity

 

Inside Diameter (I.D.)

 

Width (W)

 

Voltage

 

Wattage

 

Basic Construction Type

 

Lead Lengths Desired

2021年5月31日 13:54
浏览量:0
收藏